Offipalsta.COM  

Palaa takaisin   Offipalsta.COM > Osto ja myynti > O/M/V Varaosat ja tarvikkeet
Rekisteröidy Offiblogit Yhteisö Kalenteri Viestit tänään Haku

O/M/V Varaosat ja tarvikkeet Autojen varaosat, sekä kaikki offitarvikkeet - vinssit, liinat, tunkit yms. tänne osastolle.

Vastaus
 
Työkalut Etsi tästä viestiketjusta Näkymä
  #1  
Vanha 26.01.2013, 10:26
Ylermi:n Avatar
Ylermi Ylermi ei ole kirjautuneena
Aktiivijäsen+
 
Rekisteröitynyt: 01.06.07
Sijainti: Järvenpää
Viestit: 262
Perusasetus

Suzuki 413 jakikseen palikkaa Myyty!


Myyty

vapaa suomennos:
-413/samurai traigear 6.5 jakolaatikon välitys sarja
-sama jakis laakeri sarja tiivareineen
-vahvempi etukardaanin ulostuloakseli
-uusi mutteri kardaanilaipan kiinnitykseen


niin ja rojut sijaitsee helsingissä



1.Low range gears are critical for technical off-road driving. Our Samurai low range gear kit is the highest quality gear set available. Low Range reduction is 6.5 to 1. High Range reduction is 20% (1.7 to 1). No welded or second rate, gears here. These are strong, run quiet and take a huge amount of abuse. This complete kit includes four new precision cut gears, counter shaft, needle bearings, shims, o-ring, gaskets, and input/output seals. Heavy duty front output shaft recommended . Minor grinding of case is necessary for installation. Fits 1986-1995 Suzuki Samurai's. 15 lbs.
If you're planning to run with stock axle gears, the high-range gearing of this kit is ideal for street use with 33"-35" tires.

2.Transfer-case rebuild kit with bearings, gaskets and seals.

3.Fits input and output shaft flanges on 1986-1995 Samurai Transfer Cases. Factory original replacement part.

4.Putting in lower transfer case gears and really getting on the throttle can sometimes damage the front output shaft. This results in a loud popping noise under load and is detrimental to the life of the output shaft. Repeated popping of the front output shaft gear will result in gear failure and loss of power to the front axle. In 1993 Suzuki upgraded the output shaft and stopped using the older style shaft that was prone to failure. These later style shafts are a drop in replacement for 1986-1989 transfer cases. This upgrade is especially good for transfer cases that have lower than stock gearing in them because the lower the gear, the higher the toque load going through the gear. The front output gear can be installed without full disassembly of the transfer case. Only the front output cover needs to be removed to install this gear. Replace your older gear now and keep it in your tool box as a trail spare. Fits 1986-1995 Suzuki Samurai's. 2 lbs.

Tuollanen setti olisi kaupan!
H.850,00€ koko kasa

P.0400369533 Janne

Myyty

__________________
Ei riemulla rajaa kun Roverilla ajaa

Viimeksi muokannut Ylermi : 29.01.2013 13:52 Perustelu: lisää infoo
Vastaa lainaten
Vastaus


Käyttäjiä lukemassa tätä viestiketjua: 1 (0 jäsentä and 1 vierasta)
 

Pikalinkit

Samanlaisia viestiketjuja
Viestiketju Aloittaja Foorumi Vastauksia Viimeisin viesti
Myyty suzuki 413 joker O/M/V Ajoneuvot 0 06.11.2011 20:41
Ostettu varaosaluettelo malleihin SJ 413 /1 , 413 / 2 ja 413 / 3 4WD O/M/V Muut 7 16.11.2010 06:25
Ostetaan Suzuki 413 kaasari jukjamse O/M/V Varaosat ja tarvikkeet 2 23.04.2010 10:54
o:suzuki 413 jarrut mettäsika O/M/V Muut 0 23.10.2005 16:55
o/ suzuki 413 kardaani O/M/V Muut 5 10.02.2005 22:06


Sivu luotu: 18:38 (GMT +2).